Channel Master CM-6001 Specifications download pdf (Page 54)

Channel Master Operation Manual

page 48 RD Instruments

last stored in non-volatile memory (semi-permanent user settings) through

the CK-command. If the Channel Master receives a CR1, it will load into

RAM the factory default command set stored in ROM (permanent or fac-

tory settings).

10.2 Command Descriptions

Each listing includes the command’s purpose, format, default setting (if ap-

plicable) range, recommended setting, and description. When appropriate,

we include amplifying notes and examples. If a numeric value follows the

command, the Channel Master uses it to set a processing value (time, range,

percentage, processing flags). All measurement values are in metric units

(mm, cm, and dm).

? – Help Menus

Purpose Lists the major help groups.

Format x? (see description)

Description Entering ? by itself displays all command groups. To display

help for one command group, enter x?, where x is the com-

mand group you wish to view. When the Channel Master dis-

plays the help for a command group, it also shows the format

and present setting of those commands. To see the help or set-

ting for one command, enter the command followed by a ques-

tion mark. For example, to view the CB-command setting en-

ter CB?.

Examples See below.

Available Commands:

C ---------------------- Control Commands

E ---------------------- Environment Commands

L ---------------------- Fault Log Commands

P ---------------------- Performance Test Commands

T ---------------------- Time Commands

V ---------------------- Vertical Beam Commands

Y ---------------------- Display Banner

W ---------------------- Water Profiling Commands

? ---------------------- Display Main Menu

>C?

Available Commands:

CB 411 ------------------ Serial Port Control {baud;parity;stop}

CF 11110 ---------------- Set Ctrl Flags {e;p;b;s;*}

CJ 0;'0';0 -------------- SDI-12 Configuration {En/Dis,Addr,E/M }

CK ---------------------- Save Command Parameters to Flash

CR ---------------------- Restore Cmd defaults [0=user,1=factory]

CS ---------------------- Start Pinging

CZ ---------------------- Put the H-ADCP to sleep.

C? ---------------------- Display C-Command Menu

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 137 138

Comments to this Manuals

No comments

Channel Master CM-6001 Specifications Page 54

Comments to this Manuals