Channel Master CM-6001 Specifications download pdf (Page 106)

Channel Master Operation Manual

page 100 RD Instruments

For Evaluation Amplitude, Amplitude at the Surface, Standard Deviation,

Max Surface Track and Min Surface Track the following applies: If number

of bursts per ensemble is 1, then this is based on the good pings in the en-

semble. If the number of bursts per ensemble is greater than 1, then this is

based on the output from each burst which could be from individual pings

or from average RSSI data.

Table 24: Surface Track Status Output

Hex Digit Binary

Byte

Field Description

1-4 1,2 VB_STATUS_I

D / Vertical

Beam Status ID

Stores the Vertical Beam Status ID word 4000 (00 40h). LSB

is sent first.

5-12 3-6 Depth (Cor-

rected Surface

Track)

Depth based on surface track output with corrections applied.

Units: 0.1mm

13-20 7-10 Depth (Uncor-

rected Surface

Track)

Depth based on raw surface track output. Units: 0.1mm

21,22 11 Evaluation

Amplitude

Maximum detection filter evaluation amplitude. Units: Counts

23,24 12 Amplitude at

the Surface

Signal amplitude at Surface. Units: Counts

25,26 13 %Good of Sur-

face Track

Percentage of surface track pings in an ensemble burst that

are marked good based on signal strength and a comparison

with burst average depth (see VC command). Units: %

27-34 14-17 STD Surface

Track

Standard deviation of good depths from corrected surface

track pings. Units: 0.1mm

35-42 18-21 Min Surface

Track

Minimum depth of good corrected surface track. Units: 0.1mm

pings

43-50 22-25 Max Surface

Track

Maximum depth of good corrected surface track pings Units:

0.1mm

51-58 26-29 Pressure Depth

Correction

Last good difference between pressure depth and vertical

beam depth ensemble outputs. Units: 0.1mm

59-66 30-33 Depth (Uncor-

rected Pres-

sure)

Depth based on raw pressure output. Units: 0.1mm

67,68 34 %Good of

Depth based on

Pressure

Percentage of corrected pressure measurements good in the

ensemble. Units: %

69-76 35-38 STD of Depth

based on Cor-

rected Pressure

Standard deviation of good depths based on corrected pres-

sure measurements in the ensemble. Units: 0.1mm

77-84 39-42 Min of Depth

based on Cor-

rected Pressure

Minimum depth of corrected pressure measurements in the

ensemble. Units: 0.1mm

85-92 43-46 Max of Depth

based on Cor-

rected Pressure

Maximum depth of corrected pressure measurements in the

ensemble. Units: 0.1mm

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 137 138

Comments to this Manuals

No comments

Channel Master CM-6001 Specifications Page 106

Comments to this Manuals